Inactive
Total Small Business Set-Aside (FAR 19.5)
Notice ID:80NSSC23820184Q
This is a Brand Name requirement for 3M Liqui-Flux Ultra Filtration Membrane filters #W20-08N and flanges. TIME IS OF THE ESSENCE Ultra Filter Membrane Filters by 3M are used in the Oily Water Treatme...
This is a Brand Name requirement for 3M Liqui-Flux Ultra Filtration Membrane filters #W20-08N and flanges. TIME IS OF THE ESSENCE Ultra Filter Membrane Filters by 3M are used in the Oily Water Treatment System (OWS) for the 1247E facility. The design and operation of the system and performance is based on the use of these 3M Liqui-Flux UF Membrane filters only. Each day the filters are not in service, a pump and haul operation is required at additional cost to the Government as the OWS system is inactive without the #M UF Membrane filter installed. Shipping from the Vendor to: LaRC Distribution Center, 4 South Marvin Street, Hampton, VA 23681 must be included. 3M UF Membrane Specifications: Provide three 3M Ultra Filtration Membrane Filters and nine each flanges complying with the following: 1. Ultra filtration membrane shall be Model Liqui-Flux Module UF-PES Series, Type W20-08N. 2. Membrane type is Hollow fiber, inside-out 3. Membrane Material: Polyethersulfone 4. Outer/Inner diameter: 1.2mm/0.8mm 5. Housing material: PVC 6. Maximum Working pressure: 87 psi 7. Maximum working temperature: 104 Deg. F. 8. Typical flux range, filtration 29-88 gal.ft2day 9. Filtrate Flow rate Range 22-62 GPM 10. Typical transmembrane pressure, filtration: 1.5-10 psi 11. Typical transmembrane pressure, backwash: 7-30 psi. 12. Typical Cleaning Chemicals NaOH, HCL, NaOCl 13. pH range during cleaning: 1-13 14. Nine each PVC flanges with rotating flange for match with 2 ½-inch flanged filter port dimensions. 15. The UF Membrane Filter shall be equipped with one filtrate port top center, with radial top and radial bottom ports. 16. Regulatory compliance: ANSI/NSF61