Inactive

The measurements for the table: Worktable measures 26 9" long x VARIES" wide x 36" high. The top is 14 gauge stainless steel with all four sides turned straight down 1 1/2" and back 1/2" at 60 degrees... The measurements for the table: Worktable measures 26 9" long x VARIES" wide x 36" high. The top is 14 gauge stainless steel with all four sides turned straight down 1 1/2" and back 1/2" at 60 degrees from vertical. The base of the table is fully open and supported by 1 5/8" O.D. x .065 thick stainless steel tubular legs fitted with stainless steel leg sockets and adjustable stainless steel bullet feet. The stainless steel shelf is continuously welded to the legs at approximately 10" off the finished floor with all four sides turned straight down 1 1/2" and back 1/2" at 60 degrees from vertical. Table to have 3 sinks, lever drain, small scrap basket, 12 back splash, 2 extra shelves on far right end, and marine edge, splash mount faucet and pre rinse. The install shall include: GILL MARKETING Model No. INSTALL Gill Marketing (GM) will install L shaped three compartment sink and table to include the following: GM will disconnect plumbing from existing table. GM will remove existing sink and table and move to loading dock to remain Government property. GM will uncrate and set in place new L shaped sink. GM will weld and polish one seam. GM will install faucet and pre rinse spray units. GM will make final utility connections to existing plumbing at terminating point on the same floor level. VAMC to dispose of existing unit. VAMC to verify proper sized utilities at terminating points on the same floor level.