Inactive Total Small Business Set-Aside (FAR 19.5)

The FAA is searching for 8(a) certified, Service Disable Veteran Owned, Women Owned; HUB-zoned Small Business or other small business concerns qualified in NAICS 236220 as its primary NAICS. The contr... The FAA is searching for 8(a) certified, Service Disable Veteran Owned, Women Owned; HUB-zoned Small Business or other small business concerns qualified in NAICS 236220 as its primary NAICS. The contractor shall furnish all labor, supervision, supplies, materials, tools, equipment, transportation, and any other incidental engineering the replacement of the caulking on the Islip MacArthur Air Traffic Control Tower (ATCT)shaft located in Islip NY. A concrete sealer will be applied to the ATCT Shaft Precast Concrete. Where stated in this document that caulking is to be replaced, remove all exiting caulking, prepare the existing surface as per manufacturer’s requirements and replace the caulking as per the requirements of the contract and manufacturer’s specifications. This project will require the use of an aerial lift. The contractor shall follow all applicable safety regulations (local, FAA and OSHA) for fall protection at all times. The height to reach the upper levels of the required work is approximately 135 foot above grade. The contractor is required to attend a site visit. The site visit provides the opportunity for the contractor to determine the site restrictions (available property, roadways, facility base building, etc.), the height of the required aerial lift and for the contactor to verify all quantities, linear feet (LF) of caulking to be replaced. Prior to starting construction, the contractor shall perform a manufacturer’s adhesion test with the building sealant (caulking) for our site condition. After this test the contractor will determine what the installation requirements are. The contractor shall provide a manufacturer’s 20-year written warranty for the building sealant (caulking) installed. The minimum thickness of the caulking joint shall equal ½ the width of the caulk joint. Replace the caulking backer rod as required. Ensure that all backer rod is set at a depth to provide the required thickness of caulking. The contractor shall confirm all quantities of caulking to be replaced and site conditions affecting the height of the aerial lift required before submitting their bid. All debris generated shall be cleaned up and disposed of at the end of each work shift. The contractor shall restore all grass areas of the site after construction (provide topsoil and grass seed). Prior to construction, the contractor shall meet with the FAA Resident Engineer and review and complete the FAA PRE-CONSTRUCTION AND MAINTENANCE PROJECT SAFETY AND HEALTH CHECKLIST.