Inactive Total Small Business Set-Aside (FAR 19.5)

Amendment 0001 issued to 140P1419R0002 for the following: 1) Add "25 MPH" to the inbound lanes at the West Entrance 2) In response to question asked: clarification for Montana State Highway Specificat... Amendment 0001 issued to 140P1419R0002 for the following: 1) Add "25 MPH" to the inbound lanes at the West Entrance 2) In response to question asked: clarification for Montana State Highway Specifications Article M-280.02 (E) https://www.mdt.mt.gov/business/contracting/standard_specs.shtml Go into "Division 700 - Materials" and the Pavement Markings Specs begins on Page 507. 3) In response to question asked: Can a Federal Specification TT-P-1952E Type II or Type III Paint along with AASHTO M247-11 Type I Glass Beads be used? Only Montana Specs are acceptable 4) In response to question asked: Clarify the striping limits on Mammoth Area Roads, Lake Developed Area and Grant Developed Area. Maps attached but breakdown is as follows: Mammoth approx. 2.3 miles; Lake approx. 1.7 miles; Grant approx. 2.5 miles 5)Striping at Grant can be done along with Summer Striping under Bid Item No.1 POP 7/22/2019 - 8/31/2019 as chip seal will not be done at Grant. Striping of roadways, intersections, and parking areas throughout Yellowstone. All striping work shall be in accordance with current Manual Uniform Traffic Control Devices (MUTCD) standards.

Inactive

Synopsis: This sources sought, in accordance with FAR Part 10, is to conduct market research on industry capability to provide road striping for the Department of Interior, National Park Service, at Y... Synopsis: This sources sought, in accordance with FAR Part 10, is to conduct market research on industry capability to provide road striping for the Department of Interior, National Park Service, at Yellowstone National Park. See attached word document for further details.