Inactive

NSI Onsite Training – Standard (32 hours) – Overview of NSI System (X5000w/FXE-225.48 & HPX-450-11, # 786) Serial number 1206786, general X-Ray components and basic operations – Software overview: efX... NSI Onsite Training – Standard (32 hours) – Overview of NSI System (X5000w/FXE-225.48 & HPX-450-11, # 786) Serial number 1206786, general X-Ray components and basic operations – Software overview: efX-DR, efx-View, efX-CT, efX-Review, VorteX, SubpiX and MosaiX (if applicable) – Overview of motion control and configuration – Scanning CT reconstruction techniques applicable to customer-specific parts/samples and inspection requirements. Must inclued a 12 Point Inspection preformed on a bi-annual basis by factory trained technicians and authorized imaging specialists. The 12 Point Inspection System Maintenance Includes: Clean, inspect X-Ray Tubes, replace O-rings and adjust to manufacturers specs. Clean, inspect, reapply dielectric grease to HV cables and set compression. Clean, inspect, and lubricate manipulator. Clean cooler and test flow and temperature switches. Clean and verify adjustments on the HT generators to prolong tube filament life. Test and adjust Safety Interlocks and Safety Lamps. Test power supplies and adjust to factory specifications. Test and adjust shutter. Service vacuum system. Inspect for proper cable drape. Verify emergency stop operation. Perform a Radiation Safety Survey with documentation. Upon completion of the 12 Point Inspection and Preventive Maintenance the assigned technician/imaging specialist will provide documentation of findings and recommendations.