Inactive Total Small Business Set-Aside (FAR 19.5)

Location of work to be performed: USCGC MARIA BRAY (WLM-562) 4200 Ocean St. Atlantic Beach, FL, 32233 Period of Performance: 1 day, Oct 2020 Points of Contact: Vessel: EMCS Richard Hutchinson (727) 42... Location of work to be performed: USCGC MARIA BRAY (WLM-562) 4200 Ocean St. Atlantic Beach, FL, 32233 Period of Performance: 1 day, Oct 2020 Points of Contact: Vessel: EMCS Richard Hutchinson (727) 420-3114 (904) 564-7564 Richard.S.Hutchinson@uscg.mil Product Line Support: LTJG Monte (443) 462-0582 Alexander.C.Monte@uscg.mil Vessel Details: 175’ Keeper-class cutter equipped with Heat pumps which are required for electrical components in ECC space. Base access is gained by establishing communication with vessel point of contact. Description of Problem: After replacing the HP contactor and wires on terminal board, Unit tripped off on Low Pressure. TCI Mechanical recommended an extensive troubleshoot procedure in condensing unit. Work to be performed: Technical representative to travel to cutter and troubleshoot the current condition of the 1A and 1B HP. Perform pressure test to determine further leaks, replace additional contactors as necessary. Perform operational test to include but not limited to system start up, verification of calibration, verification of correct installation, and troubleshooting and repairs that may be accomplished using parts funded by this requisition. Any additional parts identified as necessary that are recommended for renewal must be approved through additional funding and possible extension of visit via Change Request Form (CFR) or a subsequent service performed later.