Inactive

This solicitation is issued as a Request for Proposal (RFP) prepared in accordance with the format in FAR Subpart 12.603 as supplemented with additional information included in this notice. The solici... This solicitation is issued as a Request for Proposal (RFP) prepared in accordance with the format in FAR Subpart 12.603 as supplemented with additional information included in this notice. The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2005-97. The applicable North America Industry Classification Standard (NAICS) code is 454310. Requirement: FEMA is seeking contracting alternatives and sources to provide propane/propane service for disaster survivors in response to the California wildfires. Propane is needed for heating water, cooking and heating of the travel trailer units in the affected counties. SAM.GOV REGISTRATION / LOCAL PREFERENCE (CALIFORNIA): This solicitation requires registration with the System for Award Management (SAM) to be considered for award, pursuant to applicable regulations and guidelines. Registration information can be found at www.sam.gov. Registration must be "ACTIVE" within 30 days of award. Preference will be given to businesses located within the affected counties (Butte, Los Angeles and Ventura County). If no sufficient bids are received from the affected counties, preference will be given to businesses located within California. This requirement will be evaluated based on the Lowest Priced Technically Acceptable (LPTA): 1. Each quote will be evaluated based on total price and estimated delivery schedule after award. 2. Delivery should occur within 48 hours after award. This will be a Firm-Fixed Priced purchase order. Please provide a price quote using the attached spreadsheet. All questions and concerns are due no later than 02/09/2019. Proposal are due no later than 02/11/2019, and they shall be submitted electronically to Khristine.jackson@fema.dhs.gov. FAR 52.212-1, Instructions to Offerors - Commercial Items, applies to this acquisition; FAR 52.212-3, Offeror Representations and Certifications - Commercial Items - the selected offeror must submit a completed copy of the listed representations and certifications; FAR 52.212-4, Contract Terms and Conditions - Commercial Items; FAR 52.212-5, Contract Terms and Conditions Required To Implement Statutes or Executive Orders-Commercial Items, paragraph (a) and the following clauses in paragraph (b): 52.222-21, 52.222-26, 52.222-35, 52.222-36, 52.222-37, 52.225-13, 52.232-34. The full text of the referenced FAR clauses may be accessed electronically at https://www.acquisition.gov/far/. 52.225-1 -- Buy American-Supplies. (May 2014) (a) Definitions. As used in this clause-- "Commercially available off-the-shelf (COTS) item"- (1) Means any item of supply (including construction material) that is- (i) A commercial item (as defined in paragraph (1) of the definition at FAR 2.101); (ii) Sold in substantial quantities in the commercial marketplace; and (iii) Offered to the Government, under a contract or subcontract at any tier, without modification, in the same form in which it is sold in the commercial marketplace; and (2) Does not include bulk cargo, as defined in 46 U.S.C. 40102(4), such as agricultural products and petroleum products. "Component" means an article, material, or supply incorporated directly into an end product. "Cost of components" means-- (1) For components purchased by the Contractor, the acquisition cost, including transportation costs to the place of incorporation into the end product (whether or not such costs are paid to a domestic firm), and any applicable duty (whether or not a duty-free entry certificate is issued); or (2) For components manufactured by the Contractor, all costs associated with the manufacture of the component, including transportation costs as described in paragraph (1) of this definition, plus allocable overhead costs, but excluding profit. Cost of components does not include any costs associated with the manufacture of the end product. "Domestic end product" means- (1) An unmanufactured end product mined or produced in the United States; (2) An end product manufactured in the United States, if- (i) The cost of its components mined, produced, or manufactured in the United States exceeds 50 percent of the cost of all its components. Components of foreign origin of the same class or kind as those that the agency determines are not mined, produced, or manufactured in sufficient and reasonably available commercial quantities of a satisfactory quality are treated as domestic. Scrap generated, collected, and prepared for processing in the United States is considered domestic; or (ii) The end product is a COTS item. "End product" means those articles, materials, and supplies to be acquired under the contract for public use. "Foreign end product" means an end product other than a domestic end product. "United States" means the 50 States, the District of Columbia, and outlying areas. (b) 41 U.S.C. chapter 83, Buy American, provides a preference for domestic end products for supplies acquired for use in the United States. In accordance with 41 U.S.C. 1907, the component test of the Buy American statute is waived for an end product that is a COTS item (See 12.505(a)(1)). (c) Offerors may obtain from the Contracting Officer a list of foreign articles that the Contracting Officer will treat as domestic for this contract. (d) The Contractor shall deliver only domestic end products except to the extent that it specified delivery of foreign end products in the provision of the solicitation entitled "Buy American Certificate." (End of clause) 52.225-2 -- Buy American Certificate. (May 2014) (a) The offeror certifies that each end product, except those listed in paragraph (b) of this provision, is a domestic end product and that for other than COTS items, the offeror has considered components of unknown origin to have been mined, produced, or manufactured outside the United States. The offeror shall list as foreign end products those end products manufactured in the United States that do not qualify as domestic end products, i.e., an end product that is not a COTS item and does not meet the component test in paragraph (2) of the definition of "domestic end product." The terms "commercially available off-the-shelf (COTS) item," "component," "domestic end product," "end product," "foreign end product," and "United States" are defined in the clause of this solicitation entitled "Buy American-Supplies." (b) Foreign End Products: Line Item No.: Country of Origin: [List as necessary] (c) The Government will evaluate offers in accordance with the policies and procedures of Part 25 of the Federal Acquisition Regulation. (End of Provision) 52.225-4 -- Buy American -- Free Trade Agreements - Israeli Trade Act Certificate. Alternate I (May 2014) (a) The offeror certifies that each end product, except those listed in paragraph (b) or (c) of this provision, is a domestic end product and that for other than COTS items, the offeror has considered components of unknown origin to have been mined, produced, or manufactured outside the United States. The terms "Bahrainian, Moroccan, Omani, Panamanian, or Peruvian end product," "commercially available off-the-shelf item," "component," "domestic end product," "end product," "foreign end product," "Free Trade Agreement country," "Free Trade Agreement country end product," "Israeli end product," and "United States" are defined in the clause of this solicitation entitled "Buy American-Free Trade Agreements-Israeli Trade Act." (b) The offeror certifies that the following supplies are Canadian end products as defined in the clause of this solicitation entitled "Buy American--Free Trade Agreements--Israeli Trade Act": Canadian End Products: Line Item No.---------------------------------------------------------- (c) The offeror shall list those supplies that are foreign end products (other than those listed in paragraph (b) of this provision) as defined in the clause of this solicitation entitled "Buy American--Free Trade Agreement--Israeli Trade Act." The offeror shall list as other foreign end products those end products manufactured in the United States that do not qualify as domestic end products, i.e., an end product that is not a COTS item and does not meet the component test in paragraph (2) of the definition of "domestic end product." Other Foreign End Products: Line Item No.: Country of Origin: [List as necessary] (d) The Government will evaluate offers in accordance with the policies and procedures of Part 25 of the Federal Acquisition Regulation. (End of provision) 52.225-25 -- Prohibition on Contracting with Entities Engaging in Certain Activities or Transactions Relating to Iran - Representation and Certifications. See full clause description at http://farsite.hill.af.mil/vmfara.htm 52.226-3 - Disaster or Emergency Area Representation. (Nov 2007) (a) Set-aside area. The area covered in this contract is: Butte County, Los Angeles County, and Ventura Counties as declared under DR-4407-CA. (b) Representations. The offeror represents that it [ ] does [ ] does not reside or primarily do business in the set-aside area. (c) An offeror is considered to be residing or primarily doing business in the set-aside area if, during the last twelve months- (1) The offeror had its main operating office in the area; and (2) That office generated at least half of the offeror's gross revenues and employed at least half of the offeror's permanent employees. (d) If the offeror does not meet the criteria in paragraph (c) of this provision, factors to be considered in determining whether an offeror resides or primarily does business in the set-aside area include- (1) Physical location(s) of the offeror's permanent office(s) and date any office in the set-aside area(s) was established; (2) Current state licenses; (3) Record of past work in the set-aside area(s) (e.g., how much and for how long); (4) Contractual history the offeror has had with subcontractors and/or suppliers in the set-aside area; (5) Percentage of the offeror's gross revenues attributable to work performed in the set-aside area; (6) Number of permanent employees the offeror employs in the set-aside area; (7) Membership in local and state organizations in the set-aside area; and (8) Other evidence that establishes the offeror resides or primarily does business in the set-aside area. For example, sole proprietorships may submit utility bills and bank statements. (e) If the offeror represents it resides or primarily does business in the set-aside area, the offeror shall furnish documentation to support its representation if requested by the Contracting Officer. The solicitation may require the offeror to submit with its offer documentation to support the representation. (End of provision) 52.226-4 - Notice of Disaster or Emergency Area Set-Aside. (Nov 2007) (a) Set-aside area. Offers are solicited only from businesses residing or primarily doing business in Butte County, Los Angeles County, and Ventura Counties as declared under DR-4407-CA. Offers received from other businesses shall not be considered. (b) This set-aside is in addition to any small business set-aside contained in this contract. (End of provision) 52.226-5 - Restrictions on Subcontracting Outside Disaster or Emergency Area. (Nov 2007) (a) Definitions. The definitions of the following terms used in this clause are found in the Small Business Administration regulations at 13 CFR 125.6(e): cost of the contract, cost of contract performance incurred for personnel, cost of manufacturing, cost of materials, personnel, and subcontracting. (b) The Contractor agrees that in performance of the contract in the case of a contract for- (1) Services (except construction). At least 50 percent of the cost of contract performance incurred for personnel shall be expended for employees of the Contractor or employees of other businesses residing or primarily doing business