Inactive

The Engineer Research and Development Center (ERDC), Coastal and Hydraulics Laboratory (CHL) is seeking potential sources for a Constant Rate of Strain Soil Consolidation Device. Potential suppliers o... The Engineer Research and Development Center (ERDC), Coastal and Hydraulics Laboratory (CHL) is seeking potential sources for a Constant Rate of Strain Soil Consolidation Device. Potential suppliers of this equipment are invited to provide capabilities and potential solution via email to CHL-CT-Quotes@usace.army.mil not later than 2pm (CST) 16 June 2023. Please add Email Subject "Sources Sought Response - Constant Rate of Strain Soil Consolidation Device" to your response. Quotations are not sought at this time. When providing a response, please provide CAGE Code, UEI, and Socioeconomic Indicators (if applicable). Requirements for ALL EQUIPMENT listed below: Equipment shall be new or in unused condition. Used or refurbished equipment will not be considered. Constant Rate of Strain soil consolidation device (CRS). Removable CRS cells to hold soil during consolidation process, 100 mm x 22m high. Load frame capacity of 10 kN. Pressure transducer with capacity of 100 kPa. Accuracy 0.10% of full range output. Internal load cell capacity of 1 kN, submersible, with accuracy within 0.1% of full range output. Linear displacement transducer to measure vertical displacement during experiment, including all cables. Accuracy within 0.075%. Range of 25 mm. CRS cells must include pressure connections with hydraulic lines to connect to a hydraulic pump, to include tubing, sealant, grease, pipe cutter, all pipe junctions, nut and ferrules for connections. Hydraulic pump (pressure / volume controller) with automated protection against exceeding maximum pressure/volume limits of equipment. Volume change must be measured to within 1 cubic millimeter. Hydraulic pump volume accuracy within 0.25% of the measured value, and pressure accuracy withing 0.15% of the full range. Pressure should be regulated to 0.1 kPa. Includes De-Airing block for pressure transducer with non-volume change valve. Software to prepare CRS experiment, run CRS experiment, acquire and process data during experiment, and export data included. Includes all USB and power cables. Remote Installation, calibration, and training for 4 people Delivery: Equipment shall be delivered to: U.S. Army Engineer Research and Development Center (ERDC), 3909 Halls Ferry Road, Vicksburg, MS 39180-6199 Delivery Timeframe: Within 12 weeks of contract award. Warranty: The vendor shall provide warranty of at least one year. The vendor will provide assistance regarding any troubleshooting with the product.