Inactive
Total Small Business Set-Aside (FAR 19.5)
Notice ID:W912ES22Q0036
This is a pre-solicitation notice for planning purposes only. No bids, proposals, or quotes will be accepted until the solicitation notice has been posted. The U.S. Army Corps of Engineers (USACE), St...
This is a pre-solicitation notice for planning purposes only. No bids, proposals, or quotes will be accepted until the solicitation notice has been posted. The U.S. Army Corps of Engineers (USACE), St. Paul District has a requirement for ASTM A709 HPS 50W Steel Plate For Miter Gate Anchorages. Plate specifications is as follows; ASTM A709 HPS 50W. Dimensions of master plate is 4” thick x 8’ x 20’ and then cut into three equal sections of 4” x 6’ 8” x 8’ (plus/minus ½”). See attached drawing. A 4” x 4” sample of steel to be cut from any of the four corners of each piece is acceptable to conduct testing. Per ASTM A709 Paragraph 4.1 and 4.2, “W” denotes the requirement for impact testing of the material, where “W” denotes that the material will be used for fracture critical, tension components (See Paragraph 10.2 Referring then to Table 10). Minimum tensile strength of 110-130 ksi (760-895 MPa) Charpy V-Notch impact toughness minimum of 35 ft lbs @ -30 F (48J @ -34C) (all zones) Must conform to Buy American Act. Final product shall be clean and free of any oil or grease, dross, slag or burrs. All cut edges (regardless of method) shall have a surface roughness acceptable for welding. Final product shall be legibly marked with the applicable designation, grade, heat number, size and thickness, name brand, or trademark of the manufacturer for identification and shipment. Bundle and band the steel material as required for shipping, with cribbing at minimum six inches above the base of the shipping platform to allow offloading with a forklift and/or crane. Covering of the material during shipment is not required. The North American Industry Classification System (NAICS) code for this project will be 331110; Iron and Steel Mills and Ferroalloy Manufacturing with a size standard of 1,500 employees. The resulting contract shall be a Firm, Fixed-Price contract. The solicitation shall be a Total Small Business set-aside. The solicitation will be a Request for Quote (RFQ). This synopsis is not a request for quotes, proposals, or bids. This is a notice that a solicitation for a competitive acquisition for the award of one firm-fixed price contract is intended to be issued via Contract Opportunities (https://sam.gov/content/opportunities) in the near future. The specifications will be detailed in the solicitation. This announcement is for information and planning purposes only and is not to be construed as a commitment by the Government, implied or otherwise, to issue a solicitation or award a contract. No CD's or hard copies of this notice or the solicitation will be available. Offerors are responsible for checking the above listed Contract Opportunities website for any update(s) to the Notice. The Government is not responsible for any loss of Internet connectivity or for an offeror's inability to access the document posted at the referenced website. In order for contractors to conduct business with the Department of Defense, the contractor must provide registration information to the System for Award Management (SAM). All Offerors must be registered in SAM prior to receiving an award, have an active SAM account, and have the Representations and Certifications (FAR and DFARS) sections completed prior to award. Registration instructions may be obtained, and online registration may be accomplished, at https://sam.gov/content/entity-landing.
