Inactive Total Small Business Set-Aside (FAR 19.5)

GENERAL INFORMATION: The U.S. Army Corps of Engineers requires one (1) small Articulated Loader for Snow Removal and Attachments to be delivered to Albeni Falls Dam in Oldtown, Idaho. SPECIFICATIONS: ... GENERAL INFORMATION: The U.S. Army Corps of Engineers requires one (1) small Articulated Loader for Snow Removal and Attachments to be delivered to Albeni Falls Dam in Oldtown, Idaho. SPECIFICATIONS: The loader and attachments shall meet or exceed this requirement as specified and shall have the following minimum salient characteristics: ENGINE: - Non DEF - Fuel type: diesel - Spark arrestor muffler - Glow plugs for Diesel engine and block heater - Horsepower 24.5 minimum, 25 maximum - Tier 4 EPA approved PERFORMANCE: - Designed for a sitting operator in fully enclosed cab - All controls must be accessible from the operator station - Drivability of the machine will be of articulating style - Travels multi directional from the operator controls - Tire chains included for each of the four wheels for snow and ice environments - Transmission is hydrostatic - Operating speed, 7.5mph minimum and 8.5mph maximum DIMENSIONS: - Width of the machine: 44 inch maximum - Length without attached equipment, 101 inch minimum, 93 inch maximum - Bucket hinge pin height, minimum 85 inch HYDRAULICS: - Pump Capacity: 9.5 gallons per minute minimum - Auxiliary standard flow: 9.5 gallons per minute minimum - Auxiliary Pressure: 2,900 psi minimum REQUIRED OPTION ITEMS: - Enclosed cab with heating and wind shield wiper/fluid - Horn - Beacon light kit - Road light kit: high/low beams and turn indicators - Equipped with a mounted fire extinguisher - Backup alarm - Auto idle - Neutral start interlocks - LED work lights - Auxiliary hydraulics with selectable flow and arm mounted flush face quick couplers - Control console locks - Engine and hydraulic monitor with shutdown protection - Fingertip auxiliary hydraulic control - Hydraulic joystick controls - Built-in tie down & crane/lift locations - Lift arm Support Device - Rubber wheels - Quick change attachment mounting system to allow attachment change without additional tools - Counterweight add-on kit for optimal performance with required options and attachments - Roll over protection structure - Parking brake - Equipped with Traction Assist ATTACHMENTS: All attachments must be supplied with a quick coupling system to allow the attachment to be changed out without additional tools. All hoses necessary to operate the attachment must be supplied with each attachment. All wiring harnesses, motor packages, and controls necessary for the attachments must be included and installed. All attachments must be sized appropriately for the machine and be ready to use immediately upon delivery. If any installation service is required for attachments to function properly, the installation service must be completed prior to delivery. - 48" Max overall width, 44" Min overall width, snowblower - 60" nominal width, Snow plow, V-blade style 1. V-blade controls are to be installed and accessible to the operator from the operator station during operation - Drop style sander/salt applicator 1. If the sander is of broadcast style then a sidewalk kit must be installed for limiting the broadcasting anywhere between the range of 28 inches to 48 inches 2. The hopper capacity will be a Minimum of 8.8 cubic feet - 44" Min width, 46" max width general purpose bucket - 42" min and 44" max length, 2,500 lb (or greater) pallet forks - 43" minimum to 44" maximum broom width sweeper bucket or collecting broom 1. The sweeper controls will be accessible from the operator station STANDARD MAINTENANCE ITEMS: All items listed must be supplied with the machine. - Hydraulic oil filters - Inner air filter, plus a spare - Outer air filter, plus a spare - Engine oil filter, plus a spare - Fuel Filter, plus a spare - Oil, enough for 1 oil change - 2.5 gallons hydraulic fluid - Antifreeze / coolant, enough for 1 fluid change - 10 tubes grease, manufacturer recommended