Inactive Total Small Business Set-Aside (FAR 19.5)

Amendment 0002 has been issued. Please review amendment and incorporate changes with any quote. Reminder: All Amendments must be acknowledged as part of your offer. ***********************************... Amendment 0002 has been issued. Please review amendment and incorporate changes with any quote. Reminder: All Amendments must be acknowledged as part of your offer. ************************************************************************ The Contractor shall accomplish the following tasks: The Contractor is responsible for applying a bituminous seal coat with an additional fog seal on the asphalt access road (31st St. SE) and crest road from US Highway 52/281 through the project to the parking area at the west end of Pipestem Dam. This also includes the Pipestem Dam office entrance road. For site visit information please refer to clause 52.236-27 within the solicitation. The bituminous seal coat shall consist of emulsified asphalt applied to the existing asphalt pavement at a rate of 0.4 gallons per SY. After the application of the emulsified asphalt, Class 41 Aggregate shall be applied uniformly at a rate of 25 pounds per SY onto the emulsified asphalt with an aggregate spreader. The aggregate will be rolled with a self-propelled pneumatic-tired roller immediately behind the spreader and continue for a minimum of four complete passes. Following preparation of the surface, a water diluted asphalt emulsion Fog Seal shall be applied at a rate 0.05 Gallons per SY. After minimum cure time of the Fog Seal the contractor shall apply roadway pavement marking as per NDDOT Section 762 Pavement Marking and Detail D-762-4 Rural Roadway. A single 4-inch white line along both shoulders and centerline marking as per Table 1 located on the drawings. ***Site visit information is issued with the solicitation. 52.236-27 SITE VISIT (CONSTRUCTION) (FEB 1995) (a) The clauses at 52.236-2, Differing Site Conditions, and 52.236-3, Site Investigations and Conditions Affecting the Work, will be included in any contract awarded as a result of this solicitation. Accordingly, offerors or quoters are urged and expected to inspect the site where the work will be performed. (b) Site visit is scheduled for 10:30am (CDT) on Tuesday, 23 July 2020. Contractor must notify David Beck by 2pm (CDT) on 22 July 2020 if attending the site visit. Email: David.D.Beck@usace.army.mil Phone: 701-654-7754 (End of provision)

Inactive Total Small Business Set-Aside (FAR 19.5)

The Contractor shall accomplish the following tasks: The Contractor is responsible for applying a bituminous seal coat with an additional fog seal on the asphalt access road (31st St. SE) and crest ro... The Contractor shall accomplish the following tasks: The Contractor is responsible for applying a bituminous seal coat with an additional fog seal on the asphalt access road (31st St. SE) and crest road from US Highway 52/281 through the project to the parking area at the west end of Pipestem Dam. This also includes the Pipestem Dam office entrance road. The bituminous seal coat shall consist of emulsified asphalt applied to the existing asphalt pavement at a rate of 0.4 gallons per SY. After the application of the emulsified asphalt, Class 41 Aggregate shall be applied uniformly at a rate of 25 pounds per SY onto the emulsified asphalt with an aggregate spreader. The aggregate will be rolled with a self-propelled pneumatic-tired roller immediately behind the spreader and continue for a minimum of four complete passes. Following preparation of the surface, a water diluted asphalt emulsion Fog Seal shall be applied at a rate 0.05 Gallons per SY. After minimum cure time of the Fog Seal the contractor shall apply roadway pavement marking as per NDDOT Section 762 Pavement Marking and Detail D-762-4 Rural Roadway. A single 4-inch white line along both shoulders and centerline marking as per Table 1 located on the drawings. Bidders (Offerors): Please be advised of on-line registration requirement for Representations and Certifications Application is located in System for Award Management (SAM) database https://www.sam.gov/portal/public/SAM/. Representations and certifications are required to be updated annually as a minimum to keep information current, accurate and complete. The electronic annual representations and certifications are effective until one year from date of submission or update to SAM. Obtaining Solicitation Documents: Solicitation documents will be posted to the web via Federal Business Opportunities (www.fbo.gov). Find solicitation announcement in Federal Business Opportunities (www.fbo.gov) 1. Use the ‘Quick Search' to locate the project (by entering the solicitation number) or use the advanced search features offered in the ‘Find Opportunities' (large arrow in the middle of the page) or use the ‘Opportunities' tab followed by the ‘Advanced Search' tab. 2. By using the ‘login' feature, it allows additional search features and allows you to keep your searches. Login might be required on some solicitations that are considered restricted. 3. Once you have located your project, click on link to solicitation to view the project. Files may be downloaded from the column on the right side reading ‘All Files' or from the ‘Packages' tab. 4. If you want other vendors, sub-contractors or contractors to contact you, click on the ‘Interested Vendors' tab and then ‘Add me to Interested Vendors' link at the bottom of the page.