Inactive Total Small Business Set-Aside (FAR 19.5)

Specifications for B12 Containers IP-1 B12 Containers Quantity 40 Freight/Delivery Cost 1 B12 US DOT Type Industrial Package I (IP-1) containers Dimensions 72"L X 46"W X 23"H 10,000 lbs payload Remova... Specifications for B12 Containers IP-1 B12 Containers Quantity 40 Freight/Delivery Cost 1 B12 US DOT Type Industrial Package I (IP-1) containers Dimensions 72"L X 46"W X 23"H 10,000 lbs payload Removable lid (No Lifting "D" rings on lid) Lid gasket material to be preinstalled on lid Carbon Steel Construction Rust Inhibitive Primer Interior and Exterior with Alkyd Enamel Exterior; Paint shall be dark blue 10 Gauge bottom panel 12 Gauge side panels 12 Gauge lid 4" risers Fully welded seams 14 ea. Seal Lock Clip Closure System. NO bolt type closures. Clip retaining points must not protrude more than 1/2 inch from side of container. Each container shall have a welded on tag with stamped serial number of container. No drain plugs Shall meet the compressive load requirement set forth in Nevada National Security Site Waste Acceptance Criteria (NNSSWAC) current Revision 16-00 Container shall be CERTIFIED and certification documentation provided that each container meets the compressive strength requirements set forth in the Department of Energy - Nevada National Security Site Waste Acceptance Criteria (NNSSWAC) Rev 16-00. Containers must be designed and manufactured in compliance with the Code of Federal Regulations Title 49- Transportation, CFR parts; 171.8, 173.24, 173.410, 173.411, and 178.3. Containers must be welded by personnel certified in accordance with ASME Section IX. Inspected by certified personnel utilizing a quality control system based upon 10 CFR Part 50 Appendix B, NQA-1 and MIL-I-45208A. Container drawing(s) shall be submitted to the APG Waste Certification Official for review and approval. Containers shall be inspected and certified to meet all of the above requirements at the time of design, construction and inspection in accordance with applicable quality control procedures and instructions. Vendor's Quality Assurance Program (QAP) must have been audited within the last year by an approved NNSS waste generator. Vendor shall provide the APG Waste Certification Official Patrick Eures with container manufacturing dates to allow for an on-site inspection/audit of the containers while being manufactured. This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. The combined synopsis/solicitation number is W56ZTN-19-R-0006. This announcement constitutes the only solicitation; quotations are being requested and a written solicitation will not be issued. This solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular (FAC) 2005-95. The Government contemplates award of a Firm-Fixed Price (FFP) Purchase Order for IP-1 B12 Containers for the United States Army Garrison, Aberdeen Proving Ground (USAG-APG). This solicitation is set aside for 100% small business. The Associated North America Industry Classification Code (NAICS) is 332439. This acquisition is in accordance with FAR Part 12 Acquisition of Commercial Items, FAR Part 13.5 Simplified Procedures for Certain Commercial Items in conjunction with FAR Part 15 Contracting by Negotiation.