Inactive

This solicitation is modified to extend the due date to 9 Nov 2021 at 6PM Central. (9 Nov 2021) This solicitation is modified to attache the Justification and Approval for Other than Full and Open Com... This solicitation is modified to extend the due date to 9 Nov 2021 at 6PM Central. (9 Nov 2021) This solicitation is modified to attache the Justification and Approval for Other than Full and Open Competition. (5 Nov 2021) This solicitation, W50S72-22-Q-7200, is being issued as a Request for Quotation (RFQ). This solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular (FAC) 2021-07, effective 10 September 2021. The Government intends to solicit and award to Advantor Systems on a sole source basis. See attached Justification and Approval for Other than Full and Open Competition. The NAICS code applicable to this requirement is 334290 and the small business size standard is 750 employees. The following commercial item is requested in this solicitation: Required Line Items: 0001 – Passive Infrared Sensor and Keypad with installation. Three (3) Passive Infrared Sensor (PIR) for rooms 113, 109, and 107 in building 235. One (1) Arming/disarming PIR keypad for room 113, and one (1) arming/disarming PIR keypad to activate both 109 and 107 rooms. Reprogram side doors in room 112 to be tied into room 113 and 109/107 PIR sensors respectively. Must be compatible with the existing Advantor Intrusion Detection System. Perform turnkey installation of all components; integrate all equipment into existing Advantor Intrusion Detection System. Conduct contractor verification testing and commission system into service. Provide certification of Advantor Intrusion Detection System. Provide as-built drawings of final configuration, including device placement and wire paths. (1 EACH) *Required delivery by 1 December 2021 0002 – Wired Duress Button. One (1) wired duress button for temporary trailer. Duress button must be tied into existing alarm panel in building 265 and report signal to BDOC. Must be compatible with the existing Advantor Intrusion Detection System. Perform turnkey installation of all components; integrate all equipment into existing Advantor Intrusion Detection System. Conduct contractor verification testing and commission system into service. Provide certification of Advantor Intrusion Detection System. Provide as-built drawings of final configuration, including device placement and wire paths. (1 EACH) SUBMISSION REQUIREMENTS/RFQ TERMS: 1. Offerors shall submit ALL of the following information with their quote on attached vendor information sheet. Company/Offeror Name: Company Tax ID Number: Company P.O.C: POC Phone Number: POC E-Mail: Cage Code or DUNS Number: Place of Manufacture (Required): Anticipated Delivery Time After Receipt of Order (ARO): F.O.B. (if origin, please provide cost): Net Payment Terms (Net 30, unless otherwise noted): 2. Offerors quotes shall include adequate information (product brochures, cut sheets, technical data sheets, etc.) for the Government to determine if the item being offered meets the Minimum Specifications identified below. Links to web sites are not acceptable. Failure to provide adequate specification information will render the quote non-responsive, and it will not be considered for award. 3. FAR and DFARS provisions/clauses incorporated into this RFQ and/or the resulting contract(s) are attached. The full text of the referenced provisions/clauses may be found at http://www.acquisition.gov. Vendors must submit the Representations and Certifications from, Full Text Provisions and Clauses, with their quote only if they differ from, or have not been completed within, their System for Award Management (SAM) profile. 4. Contractors must have an active System for Award Management (SAM) registration to be eligible for award. Register or check the status of your registration at http://www.sam.gov. Please ensure your SAM profile reflects all socio-economic group(s) and NAICS Codes applicable to your business. If the NAICS code listed above is not included in your SAM profile, you must also complete the representations in FAR 52.219-1 and attach it to your quote. Contractors must submit invoices electronically using the Invoicing, Receipt, Acceptance, and Property Transfer (iRAPT) application within Wide Area Work Flow (WAWF) at https://wawf.eb.mil, and receive payment via Electronic Funds Transfer (EFT) to the bank account listed in their SAM profile. Please verify with your accounts receivable/billing department that they can comply with this billing method prior to submitting a quotation. 5. FAR 52.204-24 Representation Regarding Certain Telecommunications and Video Surveillance Services or Equipment, FAR 52.204-26 Covered Telecommunications Equipment or Services-Representation, DFARS 252.204-7016 Covered Defense Telecommunications Equipment or Services Representation, and DFARS 252.204-7017 Prohibition on the Acquisition of Covered Defense Telecommunications Equipment or Services, certifications must be filled out and returned with your quote (FAR and DFARS Section 889 Representations) if not included in company’s SAM reps & Certs. 7. Questions regarding this solicitation shall be emailed to MSgt Megan McCauley AND 1st Lt Allison Harbit. Questions and Answers will be consolidated into a single Q&A document on a non-attribution basis and posted to the solicitation. 8. Proposals are due at: 185ARW/MSC ATTN: 1st Lt Allison Harbit 2920 Headquarters Avenue Sioux City, IA 51111-1300. Proposals may be submitted by mail, hand delivered, e-mail to allison.harbit@us.af.mil AND megan.mccauley@us.af.mil. It is the vendor's responsibility to verify that quotes have been received at the Contracting Office prior to the due date and time.