Inactive Total Small Business Set-Aside (FAR 19.5)

This is a Brand Name or Equivalent requirement for Automated AC/DC DWV/IR Test System with applicable support equipment. The contractor shall provide all labor, materials, tools, transportation, suppl... This is a Brand Name or Equivalent requirement for Automated AC/DC DWV/IR Test System with applicable support equipment. The contractor shall provide all labor, materials, tools, transportation, supplies, supervision, etc. (except as noted), necessary to provide all components for three automated multi-channel AC/DC DWV/IR Test Systems to the Defense Supply Center Columbus (DSCC), Columbus, Ohio Details and specifications of the equipment needed for this acquisition are listed in Sections B and C.

Inactive Total Small Business Set-Aside (FAR 19.5)

This Acquisition has been identified as a sole source requirement Viteck LLC (073M6). This posting is a pre-solicitation notice only. No response is necessary. A formal solicitation will be posted at ... This Acquisition has been identified as a sole source requirement Viteck LLC (073M6). This posting is a pre-solicitation notice only. No response is necessary. A formal solicitation will be posted at a later time. See Attachments 1 and 2 for copies of the Statement of Work (SOW) and the Technical Specifications SOW/Technical Specifications: The contractor shall provide all labor, materials, tools, transportation, supplies, supervision, etc. (except as noted), necessary to provide all components for three automated multi-channel AC/DC DWV/IR Test Systems to the Defense Supply Center Columbus (DSCC), Columbus, Ohio. The salient characteristics of the Automated AC/DC DWV/IR Test System are as listed below: A. Three each of Vitrek Corporation, 951i 6KV AC/DCIR/LR Electrical Safety Compliance Analyzer, Brand Name or Equal with the following salient characteristics: 1. Shall be new, not refurbished. 2. Shall be supplied with Operating manual. 3. Shall have; Resolution of at least 0.1V up to 6kV. 4. Shall be capable of measurements for: AC-DWV, DC-DWV, IR, 2-wire and 4-wire resistance (upto 100k?) 5. Shall at a minimum have: Accuracy of at least 0.25% + 0.5V. 6. Shall at a minimum have: Measurement period of 1 power line cycle (50/60Hz). 7. Shall have: Discharge rate of 25mA in solid-state constant current discharge mode. 8. Shall have: NIST Traceable Calibration Certificate and ISO 17025 accredited calibration certificate with data and uncertainties of each unit (ISO-CALN-95X). 9. Shall at a minimum have: Included Accessories: Power cord and HV/Continuity Test Lead set. B. Required Upgrades and Accessories - Brand Name or Equal: 1. Three each of High Voltage Switching System Mainframe (8 card capacity) including: Serial Port, VICL Cable, MCS-964 Mating Connectors, External power source with power cord, Operator’s manual, and Certificate of Compliance. (Vitrek: 964i (Configuration # 1028A) or equivalent) 2. Three each of 7KV Single (+) Input Bus 8 Outputs, White HV Terminals. (Vitrek: HV7-8W or equivalent) 3. Three each of copies Windows version of QTPro-II with permanent software license 4. Thirty two each of TL-HVW cables (4 feet length each) with covered alligator clip and banana plug terminations C. Place of Performance The instrument shall be delivered to: Supply Center Columbus 300 North James Road, Bldg 17-3 Mark for: DLA Product Test Center, Bldg 11-7 (TE Lab) Attn: Eric Kelly (eric.kelly@dla.mil / 614-692-9862) Columbus, Ohio 43213 D. Travel (if applicable) N/A E. Invoicing Payment of invoices will be accomplished by payment through the Defense Finance and Accounting Service. Invoices will be submitted to the Wide Area Workflow (WAWF) system in accordance with DFARS 252.232-7003 Electronic Submission of Payment Requests and Receiving Reports and DFARS 252.232-7006 Wide Area Workflow Payment Instructions within 10 workdays after the conclusion of each training session. F. WAWF Acceptance DODAAC# 1. TA Lab is SL0700. G. Other Requirements: 1. Delivery: 30 days from date of the award. 2. Contractor shall give notification to Eric Kelly (eric.kelly@dla.mil /614-692-9862) when the instrument is ready to be delivered. 3. All shipping costs are to be included in the contracted price. 4. The instrument shall be delivered to: Defense Supply Center Columbus 300 North James Road, Bldg 17-3 Mark for: DLA Product Test Center, Bldg 11-7 (TE Lab) Attn: Eric Kelly (eric.kelly@dla.mil / 614-692-9862) Columbus, Ohio 43213 5. Invoices shall be submitted through Wide Area Workflow (WAWF), See DFARS Clause 252.232-7006 Wide Area Workflow Payment Instructions for detailed instructions on how to submit invoices. H. Points of Contact The Government Contract Officer: Elizabeth Hanlon Elizabeth.hanlon@dla.mil 614-692-1655 The Government Contract Officer Representative (COR): Kyle Palmer Kyle.palmer@dla.mil (614) 692-8860 DLA Land & Maritime Product Test Center, 3990 E. Broad St., Columbus OH, Bldg. 11, Section 7 The Government Technical Representative Name: Larry Baas Phone #: (614) 692-9893 Email: larry.baas@dla.mil