F-35 Controlled Temperature Storage
Amendment 0007 is being issued to change Section I to include FAR Clauses 52.223-10, Waste Reduction Program (DEVIATION 2025-O0004) and 52.223-23, Sustainable Products and Services (DEVIATION 2025-O00... Amendment 0007 is being issued to change Section I to include FAR Clauses 52.223-10, Waste Reduction Program (DEVIATION 2025-O0004) and 52.223-23, Sustainable Products and Services (DEVIATION 2025-O0004) by full text. Also, this amendment changes Section K provision 52.204-8 Annual Representations and Certifications by DEVIATION 2025-O0003) and (DEVIATION 2025-O0004) by full text. See changes to Sections I and K after Vendor Questions and Answers. Amendment 0007 is also being issued to answer additional Vendor Questions. 1) The bid opening date remains unchanged. The bid opening date is still 22 April 2025 at 1000 Pacific Time.Amendment 0006 is being issued to add another date and time for questions to be submitted which may arise from the 2nd Site Visit on 2 April, 2025. All SP3300-25-B-0001 Site Visit Questions must be received by 10:00 A.M. Pacific Standard Time on April 4, 2025.Amendment 0006 is being issued to remove and add clauses out of Section I of the Solicitation.See below for the removals and the adds.Amendment 0005 is being issued to include Attachment 2 entitled SOW Controlled Temperature Storage Revision 1 and Attachment 3 entitled Controlled Temp Storage Drawing Revision 1 (restricted) and add Attachment 10 and 11, entitled COMBINED WHSE59 AS BUILT DRAWINGS reduced and WH59 Fire Riser and Alarm Panel Photos respectively. Amendment 0005 is being issued to establish a date and time for another Site Visit. A new Site Visit will be held on 2 April 2025 at 8:00 AM PT. Submit DBIDs as you did with previous Site Visit. Participants will meet at Pass and ID Office Building 128 parking lot. Contractors vendors must check in at the Pass and ID Office Building 128. All contractors vendors are required to wear safety shoes when visiting the job site locations. The Main Gate entrance is located at the Valpico Road and South Chrisman Road intersection. The military installation address is: 25600 S. Chrisman Road, Tracy, CA 95304. Please contact Mr. Joe Orpilla at 2098394522 for directions if necessary, when onsite. Amendment 0005 is also being issued to answer Vendor Questions. Amendment 0004 is being issued to Extend the Bid Submission date to April 22, 2025. This has been done to give additional time to answer questions and revise the Statement of Work accordingly. Amendment 0003 is being issued to Extend the Bid Submission date to March 18, 2025. This has been done to give more time for the USG to answer questions stemming from the first site visit and revise the Statement of Work accordingly. This will also allow time for a new site visit .Amendment 0002 is being issued to Extend the Bid Submission date to February 11, 2025. This has been done to give time for the USG to answer the many questions stemming from the first site visit and revise the Statement of Work accordingly. This will also allow time for a new site visit if necessary.. *VENDORS NEED TO EMAIL THE CONTRACT SPECIALIST WITH THEIR CAGE CODE AT PAUL.HOLBERT@DLA.MIL TO GAIN ACCESS TO RESTRICTED DOCUMENT(S)*NOTICE: Electronic submissions are mandatory for this solicitation, utilizing the Procurement Integrated Enterprise Environment (PIEE) Solicitation Module. To submit a Bid, vendors must have the Proposal Manager Role activated in the PIEE. Detailed guidance on posting a bid is provided in the PIEE Posting Offer demo, accessible through the general 10-step process described on the PIEE platform. Additional information will be detailed in the Invitation For Bid (IFB). ELECTRONIC SOLICITATION: All documents related to this solicitation, including attachments, amendments, and notifications, are posted to the PIEE Solicitation Module. A link to these documents will be available on www.sam.gov. All Bids and amendments must be submitted through the PIEE Solicitation Module only. Hard copies of the solicitation will not be distributed. Controlled Temperature Storage. Contractor shall provide construction services to include all labor, management, supervision, tools, materials, equipment, and transportation for the procurement and construction to install a new, temperature-controlled storage room inside existing warehouse, complete with insulation, lighting, HVAC, and fire protection at Defense Distribution Depot San Joaquin, Tracy CA. in accordance with specifications and drawings. The following summary of work is for the purpose of general information and is not intended to include and describe every feature or item or to define the scope of work. It is expected that the contractor will visit the site of work and thoroughly familiarize himself with the conditions existing there. Failure on the part of the contractor to acquaint himself with the site conditions will not be sufficient reason for any increase in contract price. The scope of work includes but is not limited to the following:Contractor is to furnish all labor, management, supervision, tools, materials, equipment, and transportation to ?F-35 Controlled Temperature Storage? at DDJC with all the required components over the identified work areas. This project is 100% Small Business Set Aside. The following summary of work is for the purpose of general information and is not intended to include and describe every feature or item or to define the scope of work. It is expected that the contractor will visit the site of work and thoroughly familiarize him/herself with the conditions existing there. PROJECT DESCRIPTION: This project is required to ?F-35 Controlled Temperature Storage?. Contractor is to provide all labor, supervision, materials, tools, and equipment to install a new, temperature-controlled storage room inside existing warehouse, complete with insulation, lighting, HVAC, and fire protection in Building 59-1.Performance Period: Contractor shall commence work upon Notice to Proceed and shall complete the entire work ready for use within 365 calendar days (12 months) after receipt of Notice to Proceed. Working Hours: The work shall be performed during normal business hours which consists of an 8-1/2-hour period established by the Contracting Officer, Monday through Friday, from 7:00 a.m. to 3:30 p.m. (including clean-up), excluding Government holidays. Any work requiring power shut down shall be done on Sunday as approved by Contracting Officer in advance. Any work required to be conducted outside of regular working hours requires advance Contracting Officer approval.The NAICS Code for this procurement is 236220. The small business size standard is $45.0M.The magnitude of this construction effort is between $1,000,000 and $5,000,000.The tentative timeframe for issuance of the Invitation for Bid (IFB) solicitation SP3300-25-B-0001 for the above stated requirement is on or around December 11, 2024. The exact date and time for the pre-proposal/site visit will be stated in the solicitation. NOTICE TO VENDORS: Electronic submissions are mandatory for this solicitation, utilizing the Procurement Integrated Enterprise Environment (PIEE) Solicitation Module. To submit a Bid, vendors must have the Proposal Manager Role activated in the PIEE. Detailed guidance on posting a bid is provided in the PIEE Posting Offer demo, accessible through the general 10-step process described on the PIEE platform.ELECTRONIC SOLICITATION: All documents related to this solicitation, including attachments, amendments, and notifications, are posted to the PIEE Solicitation Module. A link to these documents will be available on www.sam.gov. All Bids and amendments must be submitted through the PIEE Solicitation Module only. Hard copies of the solicitation will not be distributed. Any questions concerning this project should be directed to the Acquisition Specialist Paul Holbert at paul.holbert@dla.mil. All questions should be submitted in writing via email to the above.Prospective bidders are cautioned concerning their responsibility to access the website for any amendments that may be issued under the IFB. There will be no advance notification of amendment issuance. Prospective bidders are advised to consult the website frequently to check for any amendments. Amendments may be issued up until the IFB due date. Failure to acknowledge amendments may render your bid ineligible for award.NOTE: All offerors MUST be registered in the System for Award Management (SAM) Database at http://www.sam.gov or an award cannot be processed. The solicitation will identify all information that the prospective offeror must submit in order to be considered for award. Failure to submit all the information requested by the solicitation may result in the bid being eliminated from consideration for award.All responsible small business concerns may submit a bid which shall be considered by this agency. The Government intends to award a contract as a result of this IFB. Award will be made to the lowest responsive, responsible bidder. An offeror must be determined responsible according to the standards of FAR Subpart 9 to be eligible for award.
Data sourced from SAM.gov.
View Official Posting »