Inactive Total Small Business Set-Aside (FAR 19.5)

Amendment 0001 incorporates below Questions and Answers #1 through #4, provided earlier, into solicitation N66604-22-R-0298, as well as updating Wage Determinaton RI20220001 Mod 5 dated 6 May 2022. Ac... Amendment 0001 incorporates below Questions and Answers #1 through #4, provided earlier, into solicitation N66604-22-R-0298, as well as updating Wage Determinaton RI20220001 Mod 5 dated 6 May 2022. Acknowledging receipt of Amendment 0001 serves to acknowledge receipt of Questions and Answers #1 through #4 as requested below. -------------------------------------------------------------------------------------------------------------------------- Questions and Answers #1 through #4 provided below and as an attachment. Proposals remain due 2:00 PM ET Tuesday 24 May 2022. Acknowledge receiving below Q&A #1-4 in administrative section of your proposal. Question #1: What is the size and who is providing the concrete pad for the new chiller? Answer #1: Contractor shall provide concrete pad for new chiller. Size of pad shall extend approximately four inches beyond its mounted equipment on all sides. See Specification Section 23 64 10 Subparagraph 3.1.8.1 Refrigeration System Equipment (PDF page 366). Government is also advising Contractor of a typographical error in above-mentioned citation in that the 400 psi strength requirement should read 4,000 psi, consistent with concrete pad detail on Drawing Sheet M-501. Also, see General Note #23 on Drawing Sheet M-001. Question #2: Who will be removing the ceiling grid? Answer #2: Pursuant to Specification Section 02 41 00, Paragraph 3.1.6 Acoustical Ceiling Tile, “Remove, neatly stack, and reuse acoustic ceiling tiles.” Similarly, Contractor shall remove grid to accommodate the Work and restore acoustical ceiling system to its original or better condition. Question #3: What are the accommodations for Contractor when installing fan coil units, chilled and condensate piping down the hallway, and each of the offices? Answer #3: Contractor shall coordinate sequencing of work with the building occupants via the NUWCDIVNPT Construction Manager, i.e., the NUWCDIVNPT Code 1022 Contracting Officer’s Representative, to be identified at time of award in Section G of the contract. Question #4: Is there a requirement to perform work off hours? Answer #4: The electrical tie-ins may require off work hours for outages. Acknowledge receiving above Q&A #1-4 in administrative section of your proposal. (End of Questions and Answers) Replace variable refrigerant volume (VRF) system for a chilled water fan coil unit system to include a chiller at Building 102. Scope includes replacing the steam valves to be connected into the direct digital control (DDC) system, connecting the energy recovery ventilators (ERV) to the system, and electric duct heaters for the ERV ducts. Contractor shall provide chiller, chilled water piping, expansion, glycol system, cassette fan coil units, controls, electric duct heaters, and electrical connections. Contractor shall provide DDC, testing and balancing, commissioning, performance verification testing, and incidental related work. Onsite Contractor supervision will require at least two qualified individuals to serve in the role of superintendent, quality control (QC) manager, and site safety and health officer. The only duties and responsibilities of the QC Manager are to manage and implement the quality control program. There is an additional requirement for a Commissioning Authority.

Inactive Total Small Business Set-Aside (FAR 19.5)

This is a pre-solicitation notice issued pursuant to FAR 5.201. Naval Undersea Warfare Center Division, Newport (NUWCDIVNPT) intends to award a Firm Fixed Price (FFP) construction contract on a compet... This is a pre-solicitation notice issued pursuant to FAR 5.201. Naval Undersea Warfare Center Division, Newport (NUWCDIVNPT) intends to award a Firm Fixed Price (FFP) construction contract on a competitive basis using FAR Part 15 Procedures. NUWCDIVNPT has a heating, ventilating, and air conditioning (HVAC) requirement for replacement of variable refrigerant volume (VRF) system for a chilled water fan coil unit system to include a chiller at Building 102. Scope includes replacing the steam valves to be connected into the DDC system, connecting the energy recovery ventilators (ERV) to the direct digital control (DDC) system, and electric duct heaters for the ERV ducts. Contractor shall provide chiller, chilled water piping, expansion, glycol system, cassette fan coil units, controls, electric duct heaters, and electrical connections. Contractor shall provide DDC, testing and balancing, commissioning, performance verification testing, and incidental related work. Onsite Contractor supervision will require at least two qualified individuals to serve in the role of superintendent, quality control (QC) manager, and site safety and health officer. The only duties and responsibilities of the QC Manager are to manage and implement the quality control program. There is an additional requirement for a Commissioning Authority. Per FAR 36.204 - Disclosure of the magnitude of construction projects, the estimated price is between $500,000 and $1,000,000. Bonds and insurance will be required. This procurement will be solicited as a 100% Small Business Set Aside, as concurred with by the NUWCDIVNPT Office of Small Business Programs (OSBP). North American Industry Classification System (NAICS) Code for this acquisition is 236220. The Small Business Size Standard is $39,500,000.00. Product Service Code is Z2AZ, Repair or alteration of other administrative facilities and service buildings. It is anticipated an organized site visit will be conducted on or about 9:30 AM Wednesday 27 Apr 2022. Further details will be released upon issuance of Request for Proposal (RFP) N66604?22?R?0298, to be posted on or about 22 Apr 2022 at U.S. System for Award Management (SAM.gov). Offerors are responsible for monitoring information posted at this website. The closing date for receipt of proposal will be established in the RFP, approximately 30 days after RFP release. Offerors must be currently registered in SAM during pre-award and post-award life cycle of the contract. Draft plans and specification are attached. Drawing set is controlled unclassified information (CUI) and may be requested via controlled access in SAM.gov. Offerors must have an unexpired SAM registration and explicitly indicate an active Commercial and Government Entity (CAGE) Code associated with their company to request, and then be approved by NUWCDIVNPT to receive, the controlled information. Inquiries may be submitted to joseph.scarpa6.civ@us.navy.mil, (401) 832 1499.