Inactive 8(a) Set-Aside (FAR 19.8)

Approximately 1,000 LF of new duct bank shall be directional bored and conductors installed adjacent to the existing duct bank, (See Photos in Section 8). All duct bank work shall adhere to the specif... Approximately 1,000 LF of new duct bank shall be directional bored and conductors installed adjacent to the existing duct bank, (See Photos in Section 8). All duct bank work shall adhere to the specifications outlined in UFC 3-550-01 Exterior Electrical Power Distribution. Verify and mark all underground utilities. Provide and place warning signs and barricades for proper traffic control in accordance with the Manual on Uniform Traffic Control Devices (MUTCD). Follow all federal, state, and local laws and regulations; while also adhering to ASTM International guidelines while performing work outlined in this SOW. Utilize OSHA approved Lock out/Tag out procedures prior to performing electrical work. Directional bore (QTY 4) new pathways for new 5” conduit. Provide and install (QTY 4) new runs of 5” conduit, including all mounts, couplings, and connectors. New conduit shall be ran into existing manholes. Provide and install pull lines in the (QTY 3) vacant conduit runs. Provide and install new cable within conduit; along with all connectors, wall mounts, and wall mount arms. New cables shall be spliced into the existing conductors. Cable shall meet the following specifications and quantities: 500MCM, 5KV, EPR Cable (3 Runs of Approximately 1,000 LF), 1/0, 600V, THHN Cable (1 Run of approximately 1,000 LF). Energize new circuit and test for proper operation. All information here-in is for reference only. The Contractor must FIELD VERIFY all existing conditions, prior to fabrication and placing orders for any new items/equipment within this SOW. The Contractor must dispose of all existing demolished/removed materials off base and will completely clean up job site after work is performed. Maintain daily site clean-up at the end of every workday during the entirety of the construction period, to prevent any hazard potential. Disposal must be in accordance with all existing Local, State, Federal and NAVFAC MIDLANT EV rules and regulations.