Inactive

Contractor shall conduct training and instruction for up to seven (7) MHE Program Support staff personnel in the procedures required to inspect, test and certify all shipboard/ashore model type Materi... Contractor shall conduct training and instruction for up to seven (7) MHE Program Support staff personnel in the procedures required to inspect, test and certify all shipboard/ashore model type Material Handling Equipment (MHE) – and associated equipment assets - in accordance with guidance procedures and requirements set forth in references (a) and (b). Contractor shall perform an operational check on all forklift batteries installed in MHE. Contractor shall provide a condition report on batteries including all recommended repair/replacement actions. Contractor shall provide training for up to seven (7) MHE Program Support staff personnel in the performance of basic corrosion control, spot painting techniques and proper marking/ stenciling on all MHE identified in Table 1 utilizing appropriate wire brush and approved application processes. Contractor shall perform these service requirements (as required), if beyond the capability and/or availability of customer activity personnel. Scope of repair work includes, but is not limited to: repair/replacement of brakes (including parking brakes, master cylinders, wheel cylinders, brake shoes, and brake lines); lights and light wiring; vehicle electronics and computers; encoder bearings; bushings; mechanical and hydraulic systems; hydraulic hoses; lifting components; repack lift and tilt cylinders as necessary; verification of error codes and completion of repairs required to clear the codes; re-stenciling; tire replacement utilizing warehouse/reserve stock and equipment tire press. Items outside the scope of work include: transmission repairs, major engine repairs, differential repairs, and repairs requiring the removal of any major component (e.g. engine, mast, counterweight, axle). Contractor shall perform a test of all rear brake systems on standard HYSTER forklifts listed in Tables 1 thru 4 by lifting the rear axle off the ground, applying the brakes and testing the brake operation. Proper operation of the rear master cylinder and wheel cylinders will be verified. Master cylinder and brake drums shall be adjusted to ensure appropriate rotational resistance of the rear wheel with brake pressure applied. Contractor shall remove, and inspect the counterweight, mounting bolt, and the base plate threads for wear on all shipboard diesel forklifts to include removing the bolt, and counter weights for inspection of rust, corrosion, and worn threads on the bolts, and threaded base plate surface. Contractor shall re-install the counterweight, and mounting bolts that are within SAE standards, and re-torque the counterweight bolts to 410 foot pounds, or replace the bolts, and re-thread the base plates that fail the visual inspection, as required.