RING,BEARING,OUTER

Notice ID:N0010427QFA25

This Navy requirement is for a Stop Bolt Bearing Retainer Assembly manufactured to NAVSEA drawing 751-7072515 and ER7072515A1, Assembly A1, with the Retainer (Part 7072515-2) made from ASTM-B150 Alloy C63200. The material is designated SPECIAL EMPHASIS/Level I for a crucial shipboard system, requiring strict quality assurance, certifications, traceability, configuration control, and source Government inspection. Contractors must maintain an ISO 9001 quality system with ISO 10012 or ANSI Z540.3/ISO 17025 calibration, or acceptable MIL-I-45208/MIL-STD-45662 alternatives, and submit required certification/test documentation. Proposed delivery is 365 days for final material, with certification CDRLs due 20 days before scheduled delivery and PNSY review/acceptance 45 working days after receipt; actual delivery days may be quoted, and early/incremental delivery is acceptable at no additional cost to the Government. Drawings will be available on SAM.gov with restricted access requiring approval and POC notification, past performance will be considered under DFARS 252.204-7024, and the procurement is issued under Emergency Acquisition Flexibilities.

Department/Ind.Agency Subtier Office
DEPT OF DEFENSE DEPT OF THE NAVY NAVSUP WEAPON SYSTEMS SUPPORT MECH
  PSC   3110 BEARINGS, ANTIFRICTION, UNMOUNTED
LOCATION: Not Given
Primary Contact
Telephone: 7176053354
Not Given


Data sourced from SAM.gov. View Official Posting »

RING,BEARING,OUTER

Notice ID:N0010427QFA25

This is an Emergency Acquisition Flexibilities procurement for a Stop Bolt Bearing Retainer Assembly built to NAVSEA drawing 751-7072515 and ER7072515A1, Assembly A1, for a crucial shipboard system where incorrect material could cause serious injury, loss of life, or loss of ship systems. The retainer must be ASTM-B150 Alloy C63200, with required chemical/mechanical certification, NDT of weld repair and/or production welds, thread and O-ring/sealing-surface inspection, welding/brazing qualification, configuration control, and full material traceability under Level I/SUBSAFE special-emphasis quality requirements. Contractors must maintain an ISO-9001 quality system (or MIL-I-45208 alternate) with acceptable calibration controls, submit a certificate of compliance, and support Government quality assurance at source; past performance will be considered in evaluation. Drawings will be available on SAM.gov with restricted access requiring approval and vendor email to the solicitation POC. Certification data CDRLs are due 20 days before scheduled delivery, PNSY review/acceptance takes 45 working days after receipt, final material delivery is 365 days, early/incremental delivery is acceptable at no additional cost to the Government, and a one-year warranty from delivery applies.

Department/Ind.Agency Subtier Office
DEPT OF DEFENSE DEPT OF THE NAVY NAVSUP WEAPON SYSTEMS SUPPORT MECH
  PSC   3110 BEARINGS, ANTIFRICTION, UNMOUNTED
LOCATION: Not Given
Primary Contact
Telephone: 7176053354
Not Given

Links (1)

Attachments (0)


Data sourced from SAM.gov. View Official Posting »