Inactive

ALL OFFERS SHOULD USE UPDATED SOLICITATION WITH INCLUDES Q&A ATTACHMENT WHEN BIDDING Project Title: RPR/ADD Hazwaste Storage Area, Multi (Bldg 227 and 242) The magnitude of this project is between $10... ALL OFFERS SHOULD USE UPDATED SOLICITATION WITH INCLUDES Q&A ATTACHMENT WHEN BIDDING Project Title: RPR/ADD Hazwaste Storage Area, Multi (Bldg 227 and 242) The magnitude of this project is between $100,000 and $250,000 U.S. Dollars. This is furnished for the convenience of prospective contractors. The actual extent of work requirements will be governed by the specifications and drawings. A pre-proposal conference/site visit will be held 24 June 2021, 10:00 hours local time, in the Contracting Conference room, Building 106. Please contact the POC's listed in Section L to coordinate attendance of the site visit. All questions regarding this requirement must be submitted to christopher.meyer.31@us.af.mil no later than 30 June 2021, 10:00 hours local time. Bids must be received by the Contracting Officer (as described in Sec L) no later than 10:00 hours local time on 13 July 2021. Bids submitted by the facsimile will NOT be accepted. IN ACCORDANCE WITH THE AGREEMENT OF DEFENSE COOPERATION BETWEEN THE U.S.A. AND THE KINGDOM OF SPAIN, ANNEX 6, ARTICLE 1(5) "SPANISH MATERIAL, LABOR, AND EQUIPMENT SHALL BE USED WHENEVER FEASIBLE AND CONSISTENT WITH THE REQUIREMENTS" “Notice to Offeror(s)/Supplier(s): Funds are not presently available for this effort. No award will be made under this solicitation until funds are available. The Government reserves the right to cancel this solicitation, either before or after the closing date. In the event the Government cancels this solicitation, the Government has no obligation to reimburse an offeror for any costs.” The work includes, but is not limited to: 1.1 Building 227 1.1.1 Demolition and disassembly works. a. Disconnection of water, electricity and sewer services as required. b. Demolish concrete ramp and subgrade. c. Disassembly chainlink fence gate for subsequent reinstallation. d. Remove roof flashing of front eave. e. Remove roof panels of front overhang. f. Cut roof purlins of front overhang. g. Cut siding panel as needed to extend the structure. h. Remove fire extinguisher to be relocated. i. Remove horn to be relocated. j. Remove strobe light to be relocated. k. Remove MAN-0-OFF switch to be relocated. l. Remove exterior light fixture to be relocated. m. Remove interior light fixtures. n. Select, treat, load and transport waste from demolition to an authorized dump or recycle plant. 1.1.2 Civil Works. a. Excavate, regrade, level and compact the area to be occupied by the new ramp. b. Provide subgrade aggregate, extend level and compact as required. c. Provide material and construct concrete ramp. d. Provide material and seal concrete joint. 1.1.3 Architectural Works a. Excavate level and compact the area to be occupied by the new addition foundation. b. Provide subgrade aggregate for new foundation, extend level and compact as required. c. Provide material and install doweled joint at foundation connection. d. Provide material and construct footings, slab and concrete walls. e. Provide material and seal concrete joints. f. Install anchor plates to concrete walls. g. Provide material and install galvanized grating per containment. h. Provide material and install drainage cast iron grates. i. Provide material and erect metal profile structure. j. Provide material and install roof and siding panels. k. Provide material and install gutter extension and downspouts. l. Provide material and install roof and siding flashings. m. Clean roof, gutters, and downspout, provide material and seal joints and flashing as needed. n. Provide material and reinstall chainlink fence gate. o. Provide material and install mezzanine bar grating. p. Connect new floor drain pit to existing drainage trench. q. Prepare metal surface, prime and paint. r. Prepare and paint interior concrete surfaces with epoxy paint. s. Provide announcement signs of allowable load limit for mezzanine. 1.1.4 Electrical Works a. Install underground conduit below the new foundation from the manhole to the electrical panel. b. Provide power incoming from the electrical manhole to the electrical panel. c. Extend lighting conduits and wiring from existing conection box to the new light fixtures. d. Extend conduits and wiring from the existing connection boxes to the new location of MAN-0_OFF switch, horn and strobe light. e. Relocate exterior light fixtures from existing front face to the new one. f. Install new LED light fixtures. g. Provide additional material and extend the grounding bars as needed. h. Provide material and install grounding lines, bars and pit for the grounding connection bars and for the metal structure. i. Perform testing and comissioning. 1.2 Building 242. 1.2.1 Architectural Works a. Clean roof, flashing and structure of dirt and vegetation. b. Clean roof and siding panels of damp stains. c. Provide material as needed and restore missing panel and flashing anchorage. d. Provide material as needed and seal joint and flashing. e. Remove loose paint from concrete pavements and walls, prepare surfaces, and apply finishes epoxy paint. f. Prepare metal surfaces, prime and paint. g. Replace door retentions for fence gate. h. Select and treat waste material and delivery to authorized dump. 1.3 Final cleaning. 1.4 Delivery of As-Built drawings. 1.5 Delivery of spatial data. The certification requirements are as follows: CERTIFICATION OF CLASSIFICATION: Bidders and/or their subcontractors must hold an updated Certificate of Classification issued by the "Registro Oficial de Licitadores y Empresas Clasificadas del Estado", covering the following groups, subgroups, and categories. The certificate holder must execute the activities related to the certificate. Group Subgroup Category C 1, 2, 7 & 9 2 I 6 2 It is highly recommended that you register to be notified of any new postings for this solicitation and/or any other postings published by our office. However, failure of the service to notify you of changes cannot be used against the Government in any way, shape or form. Therefore, you should check FedBizOps, https://www.fbo.gov , frequently for any new postings that may have been made. The Government anticipates and reserves the right, to issue all solicitation documents including specifications and drawings in the English language only. In order to be awarded a contract by the U.S. Government, the company must be registered in the System for Award Management (SAM); contracts cannot be awarded to unregistered contractors. Registration can be made online at www.sam.gov/portal/public/SAM/ NOTE: You must have a DUNS number and a NATO Commercial and Government Entity (NCAGE) Code to register. To obtain a Data Universal Numbering System (DUNS) Number you can contact Dun and Bradstreet and request one by calling: 902-446-688. To obtain a NATO CAGE code you must fill out the form found in: http://www.dlis.dla.mil/Forms/Form AC135.asp. Failure to be registered in SAM at the time of award may delay the award and depending on the criticality of the project, may be cause to award to the next qualified best value offeror who is SAM registered. However, do not delay submitting your proposal pending receipt of a DUNS number or CAGE Code.