Inactive

General Notice: This is a Sources Sought Notice for BAA/TAA compliant toilets that meet the requirements listed below. This notice is for information purposes only and IS NOT A REQUEST FOR PROPOSALS, ... General Notice: This is a Sources Sought Notice for BAA/TAA compliant toilets that meet the requirements listed below. This notice is for information purposes only and IS NOT A REQUEST FOR PROPOSALS, QUOTATIONS OR BIDS. The U.S. Army Corps of Engineers, Huntsville Center, requests capability statements from manufacturers / vendors concerning the availability of toilets that satisfy the requirements described below. Responses to this sources sought announcement will be used by the Government to make appropriate acquisition decisions. NO SOLICITATION IS CURRENTLY AVAILABLE. General Information: Responses are to be sent via email to Tina.D.Riley@usace.army.mil (phone 256-895-7796) no later than 2:00 p.m. Central Standard Time 05 December 2024. GENERAL REQUIREMENTS: The US Army Corps of Engineers, Huntsville Center is seeking BAA/TAA compliant toilets that meet the following four (4) requirements: Bowl cannot extend more than 27 inches from the wall Outlet is 10 inch rough-in from the wall Low flow toilet Top Spud bowl **Can use a standard flush valve** In addition to meeting the requirements indicated above, the toilets shall comply with the Buy American Act (BAA). The BAA provides a preference for domestic construction materials mined, produced or manufactured in the United States as defined in the Federal Acquisition Regulation (FAR) Clause, "Buy American Act - Construction Materials" (FAR 52.225-9). For construction contracts exceeding $6,708,000, the Buy American Act restrictions are waived for designated country construction materials as defined in FAR 52.225-11, "Buy American Act - Construction Materials Under Trade Agreements." SUBMISSION REQUIREMENTS: Manufacturers and/or suppliers responding to this announcement shall verify that units satisfy the general requirements indicated above. A catalog cut of the units with technical specification demonstrating this shall be included. In addition, please provide cost and place of manufacture for each unit. Responses should be submitted to the indicated point of contact with company name, address, and point of contact including email address. Responses must be received no later than 2:00 p.m. Central Standard Time on 05 December 2024.