Inactive Total Small Business Set-Aside (FAR 19.5)

SCOPE OF CONTRACT: The Contractor shall furnish all equipment and personnel necessary to remove and replace the existing Wire-Faced Retaining Wall with government furnished Hilfiker Wall material. The... SCOPE OF CONTRACT: The Contractor shall furnish all equipment and personnel necessary to remove and replace the existing Wire-Faced Retaining Wall with government furnished Hilfiker Wall material. The Contractor shall furnish all materials not provided by the government to complete the project. (See Section G) Work includes: Remove and dispose of the existing AC surface, remove and stockpile the aggregate base, excavate the existing MSE structure, dispose of all steel and fabric encasement materials, prepare the structure base, construct the new Government Furnished MSE structure with the retained rock facia including an upper and lower drain system, Backfill as needed to the sub-base level, replace the augmented road base, place a 3” course of hot asphalt, and install object markers. Specific Requirements for the Base Items are: • All existing AC and/or chip seal pavement is to be removed and disposed of away from government land. (See Section H) • Excavate the existing MSE structure. Remove the geo-fabric and metal WW cages and dispose of away from government land. • Prepare a base for and construct the new Government Furnished MSE structure as shown on the drawings. Also include installation of contractor supplied lower and upper drain system. • Place and compact suitable fill over the MSE structure to the appropriate level for reconstruction of the new paved road section. Place and compact a six-inch course of aggregate base. Clean base material previously removed from the excavation may be reused here up to 50%. • Apply a prime coat to compacted aggregate base and a tack coat to cut surfaces of remaining AC pavement. • Placing, shaping, and compacting hot-mix asphalt concrete to produce a single compacted 3” course. • Traffic control for public access and administrative travel. PROJECT LOCATION: The project is located on the Feather River Ranger District of the Plumas National Forest, California. FSR 22N94 runs along the Hartman Bar Ridge south of the Middle Fork of the Feather River. The road intersects with FSR 22N27 7.2 miles east of the community of Feather Falls, CA. Access from the east (Quincy) is via PC 511 & 514 at Little Grass Valley Res. Near La Porte, CA The project location is: Survey Location: T21N, R7E, Sec. 5, NE ¼ MAGNITUDE OF CONSTRUCTION PROJECT: The price range for this contract is: $100,000.00 to $250,000.00. RFIs to be submitted to george.staggs@usda.gov by 1200 CDT April 29, 2024.