Inactive Total Small Business Set-Aside (FAR 19.5)

Remove and dispose of 250 gallons of fuel product for Tanks 11113 and 11114. Perform an Internal AST inspection to include visual inspection of the containment area on tanks 11113 and 11114. These ins... Remove and dispose of 250 gallons of fuel product for Tanks 11113 and 11114. Perform an Internal AST inspection to include visual inspection of the containment area on tanks 11113 and 11114. These inspections must be phased. At no time will both tanks be out of service during these inspections. Coordination must be made with the installation before inspection. On tanks 11113 and 11114, existing wiper seals (foam log, double wiper etc.) shall be removed and completely replaced with a new double wiper seal in accordance with UFGS 33 56 21.17 and the IFR manufacturer's recommendations; penetration seals in floating pan will also need to be replaced. Perform an external AST inspection to include visual inspection of the containment area on STI Tanks 13467, 13468, 8604E, 8604C, 8243E, and 8243C. Any fuel or residual product that will be disposed of the contractor will be responsible to coordinate with environmental and safety authorities having jurisdiction to obtain and execute required permits, manifests, etc. Clean the tank and perform an internal AST inspection to also include the visual inspection of the containment area. Tank cleaning shall be done in accordance with UFGS 33 01 50.60. The tank Inspection shall be in conformance with applicable industry standards API 653, NFPA 30, NFPA 326, UFGS 33 01 50.60, and in compliance with 40 CFR 112, UFC 3-460-01, UFC 3-460-03 and any other applicable federal, state, local, service or host nation requirements. At a minimum, table 8-1 within UFC 3-460-01 shall be followed. Drain Line and Release Valve shall be Hydrostatically tested. The Contractor shall perform a hydrostatic test to ensure the drainpipe and release valve do not leak. Test in accordance with applicable requirements of AWWA C600 for hydrostatic testing. Ensure the release valve is closed and pressurize the end of the pipe within the containment basin sump. Test for leakage by filling the pipe with water and pressurizing to 10 psi using a suitable pump connected to the pipeline. The test pressure shall not vary by more than ±1 psi for the duration of the test. Hold this pressure for not less than 2 hours. If the system does not hold pressure, check the outfall point to see if water is bypassing the valve. Test pressure shall be maintained during the test by adding makeup water through the pressure test pump into the pipeline. Accurately note the amount of makeup water required to maintain pressure during the test. Containment Drain Inlet. The Contractor shall perform a hydrostatic test to ensure the integrity of the inlet sump. Test for leakage by filling the inlet with water to a level at least 1-2 inches above the top of the inlet structure. The inlet shall hold this water for not less than 2 hours with no measurable change in the water level. Provide telecon out briefing for OOS inspections. Provide legible tank stencil or label on tanks 11113 & 11114 consisting of black letters at least 1” in height, stating the date cleaned and inspected. Update 23 Feb 2021: Question and Answer and Attachment included in Attachments Section